Collection: 70 Series Land Cruiser Exhaust Mounts & Hardware

EXHAUST MOUNTS AND HARDWARE FOR THE 70 SERIES

THE SMALL PARTS THAT KEEP THE EXHAUST FROM RATTLING LOOSE

The exhaust on a 70 Series hangs from rubber mounts that take a beating from years of vibration, dust, water, and heat. When the rubbers perish, the exhaust starts to rattle, knock against the chassis on rough roads, and eventually crack at the flange connections from the unsupported weight. Replacement exhaust mounts and hardware in this collection cover the rubber hangers, mount brackets, exhaust bolts, gaskets, and clamps that secure the exhaust to the chassis. Small parts, but the ones that determine whether your new aftermarket exhaust lasts a decade or rattles itself apart in two years.

OEM-SPEC RUBBER AND HARDWARE

Rubber exhaust mounts are sourced to OEM specification with the right durometer rating to support the exhaust weight without compressing flat. Sold in 3 piece, 4 piece, and complete vehicle sets to suit the number of hangers under the vehicle. Exhaust flange bolts are supplied as 10 pack sets in matched lengths and thread pitches. Gaskets are precision cut to suit common 3 inch and 2.5 inch flange diameters. Each component meets or exceeds the original Toyota specification for the relevant 70 Series setup, so replacement is a straight one-for-one fit.

SUITS 40, 60, 70, 80, AND 100 SERIES

Exhaust hardware is largely shared across the Toyota Land Cruiser family from the 40 Series onwards because Toyota reuses the same hanger rubber, bolt, and gasket part numbers across multiple generations. That means a rubber mount sold for the 70 Series typically also fits the 40, 60, 80, and 100 Series. Each listing confirms exact cross-fitment so you can order the right combination for your specific vehicle. Stock the right hardware before you do an exhaust install to avoid mid-job trips to the parts shop.